Keysight Technologies B2961A - STATus Subsystem

Keysight B2961A/B2962A SCPI Command Reference, Edition 6 2- 77
Subsystem Command Summary
Using Advanced Functions
Table 2-22 STATus Subsystem
:SYST:TIME:TIM:COUN:RES:AUTO mod
e
:SYST:TIME:TIM:COUN:RES:AUTO?
Enables or disables the automatic reset
function of the timer. If this function is
enabled, the timer count is reset when the
initiate action occurs.
mode=0|OFF|1|ON
ON
:SYST:TIME:TIM:COUN:RES[:IMM]
Resets the timer count immediately.
:SYST:VERS?
Returns the version of the SCPI standard.
Command Summary Reset setting
Command Summary Reset setting
:STAT:MEAS:COND?
:STAT:OPER:COND?
:STAT:QUES:COND?
Returns the value of the measurement,
operation, or questionable status
condition register.
:STAT:MEAS:ENAB mask
:STAT:OPER:ENAB mask
:STAT:QUES:ENAB mask
:STAT:MEAS:ENAB?
:STAT:OPER:ENAB?
:STAT:QUES:ENAB?
Sets the measurement, operation, or
questionable status enable register.
mask=0 to 65535 (decimal)
0
:STAT:MEAS[:EVEN]?
:STAT:OPER[:EVEN]?
:STAT:QUES[:EVEN]?
Returns the value of the measurement,
operation, or questionable status event
register.
:STAT:MEAS:NTR filter
:STAT:OPER:NTR filter
:STAT:QUES:NTR filter
:STAT:MEAS:NTR?
:STAT:OPER:NTR?
:STAT:QUES:NTR?
Sets the negative transition filter in the
measurement, operation, or questionable
status register. If you set a bit of the filter,
a 1-to-0 transition of its register bit sets
the corresponding bit of the event
register.
filter=0 to 65535 (decimal)
0