Keysight B2961A/B2962A SCPI Command Reference, Edition 6 2- 71
Subsystem Command Summary
Using Advanced Functions
Table 2-21 SYSTem Subsystem
:PROG[:SEL]:STAT operation
:PROG[:SEL]:STAT?
Changes the execution status of a
program stored in the program memory.
operation=RUN|PAUSe|STEP|STOP|
CONTinue
:PROG[:SEL]:WAIT? timeout
Blocks other commands until the program
execution status changes to Paused or
Stopped.
timeout: Timeout value, in seconds.
:PROG:VAR[h] value
:PROG:VAR[h]?
Sets a value to the variable specified by h.
The variable is used in the program
memory. A variable can be used in a
program as %h% (h: integer. 1 to 100).
value: Value of the variable specified by
h. Up to 32 ASCII characters.
Command Summary Reset setting
:SYST:BEEP[:IMM] frequency,time
Generates a beep sound of the specified
frequency and duration.
frequency=55 to 6640 Hz
time=0.05 to 12.75 seconds
:SYST:BEEP:STAT mode
:SYST:BEEP:STAT?
Enables or disables the beeper.
mode=0|OFF|1|ON
:SYST:COMM:ENAB mode,interface
:SYST:COMM:ENAB? interface
Enables or disables the remote interface
GPIB, USB, or LAN, the remote service
Sockets, Telnet, VXI-11, HiSLIP, or the
built-in Web Interface. The setting is
effective after rebooting the instrument.
mode=0|OFF|1|ON
interface=GPIB|USB|LAN|SOCKets|
TELNet|VXI11|HISLip|WEB
Command Summary Reset setting
To Next Page
Loading...
