2- 72 Keysight B2961A/B2962A SCPI Command Reference, Edition 6
Subsystem Command Summary
Using Advanced Functions
:SYST:COMM:GPIB[:SELF]:ADDR addr
ess
:SYST:COMM:GPIB[:SELF]:ADDR?
Sets the GPIB address of the instrument.
address=0 to 30
:SYST:COMM:LAN:ADDR address
:SYST:COMM:LAN:ADDR? [CURR|STAT]
Sets the static LAN (IP) address of the
instrument. The setting is enabled by the
:SYST:COMM:LAN:UPD command.
address=A.B.C.D, 15 characters
maximum. A, B, C, and D must be a
number from 0 to 225.
CURR: Present setup value
STAT: Reserved value for the next startup
:SYST:COMM:LAN:BST?
Returns the LAN boot status of the
instrument.
Response is LAN_AUTO_IP,
LAN_DHCP, LAN_FAULT, or
LAN_STATIC.
:SYST:COMM:LAN:CONT?
:SYST:COMM:TCP:CONT?
Returns the control connection port
number of the specified port.
:SYST:COMM:LAN:DHCP mode
:SYST:COMM:LAN:DHCP?
Enables or disables the use of the
Dynamic Host Configuration Protocol
(DHCP). The setting is enabled by the
:SYST:COMM:LAN:UPD command.
mode=0|OFF|1|ON
:SYST:COMM:LAN:DNS[j] address
:SYST:COMM:LAN:DNS[j]? [CURR|STA
T]
Sets the IP address of the DNS server.
address=A.B.C.D, 15 characters
maximum. A, B, C, and D must be a
number from 0 to 255.
CURR: Present setup value
STAT: Reserved value for the next startup
:SYST:COMM:LAN:DOM?
Returns the domain name of the network
to which the instrument is connected.
Command Summary Reset setting
To Next Page
Loading...
