Keysight Technologies B2961A - [:SOURce]:ARB:<CURRent|VOLTage>:EXPonent:ST ARt[:LEVel]; [:SOURce]:ARB:<CURRent|VOLTage>:EXPonent:ST ARt:TIME

4- 102 Keysight B2961A/B2962A SCPI Command Reference, Edition 6
Subsystem Commands
SOURce Subsystem
Parameter data Exponential waveform end level. value (see “Source Output
Ranges” on page 2-36) |MINimum|MAXimum|DEFault
(default is 0.0). Parameter data type is NRf+. Query does not
support data=value.
Query response response <newline>
response returns the present setting. If a parameter is specified, response returns the
value assigned to DEF, MIN, or MAX. Response data type is NR3.
Example :ARB:CURR:EXP:END 1E-3
:SOUR2:ARB:CURR:EXP:END?
[:SOURce]:ARB:<CURRent|VOLTage>:EXPonent:ST
ARt[:LEVel]
Sets the start level of the current or voltage exponential waveform output.
Syntax [:SOURce[c]]:ARB:<CURRent|VOLTage>:EXPonent:STARt[:LEVel] data
[:SOURce[c]]:ARB:<CURRent|VOLTage>:EXPonent:STARt[:LEVel]? [data]
For <CURRent|VOLTage>, specify CURRent for current output or VOLTage fo r
voltage output.
Parameter data Exponential waveform start level. value (see “Source Output
Ranges” on page 2-36) |MINimum|MAXimum|DEFault
(default is 0.0). Parameter data type is NRf+. Query does not
support data=value.
Query response response <newline>
response returns the present setting. If a parameter is specified, response returns the
value assigned to DEF, MIN, or MAX. Response data type is NR3.
Example :ARB:CURR:EXP:STAR 1E-3
:SOUR2:ARB:CURR:EXP:STAR?
[:SOURce]:ARB:<CURRent|VOLTage>:EXPonent:ST
ARt:TIME
Sets the start time of the current or voltage exponential waveform output.