4- 166 Keysight B2961A/B2962A SCPI Command Reference, Edition 6
Subsystem Commands
SYSTem Subsystem
:SYSTem:COMMunicate:<LAN|TCPip>:CONTrol?
Returns the control connection port number of the specified port.
Syntax :SYSTem:COMMunicate:<LAN|TCPip>:CONTrol?
Query response port_number <newline>
port_number returns the control connection port number of the specified port.
Response data type is NR1.
Example :SYST:COMM:TCP:CONT?
:SYSTem:COMMunicate:LAN:DHCP
Enables or disables the use of the Dynamic Host Configuration Protocol (DHCP).
The setting is enabled by the
:SYSTem:COMMunicate:LAN:UPDate command.
This command setting is not changed by power off or the *RST command.
When DHCP is enabled, the instrument will try to obtain an IP address from a
DHCP server. If a DHCP server finds the instrument, it will assign a dynamic IP
address, subnet mask, and default gateway to the instrument. When DHCP is
disabled or unavailable, the instrument will use the static IP address, subnet mask,
and default gateway during power-on.
If a DHCP LAN address is not assigned by a DHCP server, a static IP address will
be used after a timeout of approximately 2 minutes. For the instrument boot status,
see the
:SYSTem:COMMunicate:LAN:BSTatus? command.
Syntax :SYSTem:COMMunicate:LAN:DHCP mode
:SYSTem:COMMunicate:LAN:DHCP?
Parameter mode DHCP off or on. 0|OFF|1|ON. Parameter data type is boolean.
Query response mode <newline>
mode returns 0 or 1, and indicates that DHCP is off or on, respectively. Response
data type is NR1.
Example :SYST:COMM:LAN:DHCP 0
:SYST:COMM:LAN:DHCP?
To Next Page
Loading...
Need help?
General
