Keysight B2961A/B2962A SCPI Command Reference, Edition 6 4- 171
Subsystem Commands
SYSTem Subsystem
:SYSTem:COMMunicate:LAN:WINS
Sets the IP address of the WINS server. This command setting is not changed by
power off or the *RST command.
Syntax :SYSTem:COMMunicate:LAN:WINS[j] address
:SYSTem:COMMunicate:LAN:WINS[j]? [CURRent|STATic]
Parameter address IP address of the WINS server. It must be in the A.B.C.D format
with 15 characters maximum. A, B, C, and D must be a number
from 0 to 255. Parameter data type is SPD.
Query response address <newline>
address returns the IP address of the WINS server. If the CURRent parameter is set,
address returns the present setting. If the STATic parameter is set, address returns
the reserved value for the next startup. Response data type is SRD.
Example :SYST:COMM:LAN:WINS “192.168.100.150”
:SYST:COMM:LAN:WINS2?
:SYSTem:DATA:QUANtity?
Returns the number of data for the specified channel in the data buffer.
Syntax :SYSTem:DATA:QUANtity? [chanlist]
Parameter chanlist Channels. Parameter data type is channel list.
(@1)|(@2)|(@1,2)|(@1:2)|(@2,1)|(@2:1). See
“Channel List
Parameter” on page 1-8.
(@1) selects channel 1 only. (@2) selects channel 2 only. (@1,2), (@1:2), (@2,1),
and (@2:1) selects both channels 1 and 2.
If this parameter is not specified, chanlist=(@1) is set.
Query response response <newline>
response returns the number of data. Response data type is NR1. If both channels 1
and 2 are selected by chanlist, response returns the number of channel 1 data and the
number of channel 2 data in this order. They are separated by a comma.
Example :SYST:DATA:QUAN? (@2)
To Next Page
Loading...
Need help?
General
