Keysight Technologies B2961A - :TRIGger<:ACQuire|:TRANsient|[:ALL]>:SOURce[:SI GNal]

Keysight B2961A/B2962A SCPI Command Reference, Edition 6 4- 199
Subsystem Commands
TRIGger Subsystem
:TRIGger[c]<:ACQuire|:TRANsient>:SOURce:LAN?
For <:ACQuire|:TRANsient|[:ALL]> and <:ACQuire|:TRANsient>, specify
:ACQuire for measurement, :TRANsient for source output, or :ALL for both device
actions.
Parameter lan_id LAN ID of the LXI trigger. LAN0|LAN1|LAN2|LAN3|LAN4|
LAN5|LAN6|LAN7. All is selected as default. Parameter data
type is CPD.
Query response response <newline>
response returns the present setting, LAN0 through LAN7. Response data type is
CRD. Multiple responses are separated by a comma.
Example :TRIG:SOUR:LAN LAN7
:TRIG2:TRAN:SOUR:LAN?
:TRIGger<:ACQuire|:TRANsient|[:ALL]>:SOURce[:SI
GNal]
Selects the trigger source for the specified device action.
Syntax :TRIGger[c]<:ACQuire|:TRANsient|[:ALL]>:SOURce[:SIGNal] source
:TRIGger[c]<:ACQuire|:TRANsient>:SOURce[:SIGNal]?
For <:ACQuire|:TRANsient|[:ALL]> and <:ACQuire|:TRANsient>, specify
:ACQuire for measurement, :TRANsient for source output, or :ALL for both device
actions.
Parameter source Trigger source. AINT (default)|BUS|TIMer|INT1|INT2|
LAN|EXT1|EXT2|EXT3|EXT4|EXT5|EXT6|EXT7|EXT8|EXT
9| EXT10|EXT11|EXT12|EXT13|EXT14. Parameter data type
is CPD.
source=AINT (automatic internal) automatically selects the trigger source most
suitable for the present operating mode by using internal algorithms.
source=BUS selects the remote interface trigger command such as the group
execute trigger (GET) and the
*TRG command.
source=TIMer selects a signal internally generated every interval set by the
:TRIGger<:ACQuire|:TRANsient|[:ALL]>:TIMer command.