To Next Page

To Previous Page

Keysight B2961A/B2962A SCPI Command Reference, Edition 6 4- 157

Subsystem Commands

STATus Subsystem

:STATus:<MEASurement|OPERation|QUEStionable>:

PTRansition

Sets the positive transition filter in the measurement, operation, or questionable

status register. If you set a bit of the filter, a 0-to-1 transition of its register bit sets

the corresponding bit of the event register.

Syntax :STATus:<MEASurement|OPERation|QUEStionable>:PTRansition filter

:STATus:<MEASurement|OPERation|QUEStionable>:PTRansition?

For <MEASurement|OPERation|QUEStionable>, specify MEASurement for the

measurement status register, OPERation for the operation status register, or

QUEStionable for the questionable status register.

Parameter filter Positive transition filter. 0 to 65535 (decimal). Default is 32767.

Parameter data type is NR1 or NDN.

filter is the sum of the binary-weighted values for the set bits.

Query response filter <newline>

filter returns the present setting of the positive transition filter in the specified

hexadecimal) selected by the

:FORMat:SREGister command.

Example :STAT:MEAS:PTR 32767

:STAT:QUES:PTR?

:STATus:PRESet

Sets all defined bits in the status system’s PTR registers and clears the all bits in the

NTR and Enable registers. The registers are returned to the default condition.

Syntax :STATus:PRESet

Example :STAT:PRES

:STATus:QUEStionable:<CALibration|CURRent|TEM

Perature|TEST|VOLTage>:CONDition?

Returns the value of the questionable status condition register. See Table 4-7 to 4-11

for the bit definitions. The register setting is not changed by this command.

Keysight Technologies B2961A Command Reference

Other manuals for Keysight Technologies B2961A