RDC Resolver Digital Converter
The resolver digital converter is used to acquire motor data (e.g.
position data, motor temperatures).
SC Special Connection
SE Second Encoder
SI Safe Interaction
SL Washdown
smartPAD Programming device for the robot controller
The smartPAD has all the operator control and display functions re-
quired for operating and programming the industrial robot. 2 models
exist:
• smartPAD
• smartPAD-2
In turn, for each model there are variants, e.g. with different lengths
of connecting cables.
For robot controllers of the KR C5 series, only the model “smart-
PAD-2” is used.
For other robot controllers, the designation “KUKA smartPAD” or
“smartPAD” always refers to both models unless an explicit distinc-
tion is made.
Stop category 0 The drives are deactivated immediately and the brakes are applied.
The manipulator and any external axes (optional) perform path-ori-
ented braking.
Note: This stop category is called STOP 0 in this document.
Stop category 1 The manipulator and any external axes (optional) perform path-
maintaining braking.
• Operating mode T1: the drives are deactivated as soon as the
robot has stopped, but no later than after 680 ms.
• Operating modes T2, AUT (KR C controller), AUT EXT (KR C
controller), EXT (VKR C controller):
The drives are switched off after 1.5 s.
Note: This stop category is called STOP 1 in this document.
Stop category 1 –
Drive Ramp Stop
The manipulator and any external axes (optional) perform path-ori-
ented braking.
• Operating mode T1: the drives are deactivated as soon as the
robot has stopped, but no later than after 680 ms.
• Operating modes T2, AUT (KR C controller), AUT EXT (KR C
controller), EXT (VKR C controller):
The drives are switched off after 1.5 s.
Note: This stop category is called STOP 1 - DRS in this document.
Stop category 2 The drives are not deactivated and the brakes are not applied. The
manipulator and any external axes (optional) are braked with a
path-maintaining braking ramp.
Note: This stop category is called STOP 2 in this document.
KR IONTEC
12/344 | www.kuka.com MA KR IONTEC V4 | Issued: 11.05.2021
Introduction
To Next Page
Loading...
Need help?
General
