Key Description
Back To return to the previous panel.
Redo To reject all results and to repeat the complete check and
adjust p
rocedure.
Finish To accept and store the new determined instrument errors,
which are selected. If the report sheet recording has been
enabled, then the results are written or appended to an
existing report sheet.
Description of metadata
Metadata Description
New The new determined and averaged instrument errors.
Old The old adjustment errors, which are currently valid on the
instr
ument.
22.7.5 Tilting Axis Adjustment (a)
In Check & Adjust, What do you want to do? select Check & adjust the
t
ilting axis and press Next.
This adjustment procedure determines the following instrument error:
Instrument error Description
a Tilting-axis error
Before determining the tilting-axis error, the instrument has to be:
•
le
v
elled up using the electronic level
•
protected from direct sunlight
•
acclimatised to the ambient temperature, approximately 2 minutes per °C
difference compared to the storage place.
•
The horizontal collimation error must be determined before.
Key Description
Measure To measure the target.
Access
Description
☞
Check & Adjust,
S
tep 1
Se
ttings - TS instrument 271
To Next Page
Loading...
