25 Settings - Point storage
25.1 Duplicate points
Select Leica Cap
tivate - Home: Settings\Point storage\Duplicate points.
In order to check measurements, the same point can be measured more than
onc
e. If activated, an average or an absolute difference is calculated.
The averaging is always done by using TS and GS.
Description of fields
Field Option Description
When a point
is sto
red with
same point ID
as existing
point
Defines the averaging principles for multi-
ple measured points. The selection deter-
mines the availability of the subsequent
fields for setting the acceptable averaging
limits or absolute differences.
Check the
average
Computes the average for the position and
the height. Points exceeding the defined
limits are marked with ! on the Mean page.
Check the
abs diff
Computes the absolute differences
between two points selected from a list of
measured points which are all stored with
the same point ID.
Don't check Averaging is turned off. No other fields are
available.
Method The method used for computing the aver-
age. Available for When a point is stored
with same point ID as existing point:
Check the average.
Weighted Calculates a weighted average
No weight-
ing
Calculates an arithmetic average.
Limit in posi-
tion and
Limit in
height
Editable field The acceptable difference for the position
and height components. Available for
When a point is stored with same point
ID as existing point: Check the average.
From Easting
to Cartesian Z
Editable
fields
The acceptable absolute differences for
each coordinate component. Available for
When a point is stored with same point
ID as existing point: Check the abs diff.
25.2 Prompt before storing
Select Leica Cap
tivate - Home: Settings\Point storage\Prompt before
storing.
Check a box if you want to be asked for input/selection when storing a point
with Sto
re.
Access
Duplicate Points
Access
Prompt Before Stor-
ing,
GS an
d TS page
Settings - Point storage 299
To Next Page