Key Description
More To display information about the codes if stored with any
line, the star
t time, the end time of when the last point was
added to the line, the length of the line, the perimeter and
the area.
Page To change to another page on this panel.
Fn Filter To define sort and filter settings. Refer to "7.6 Point Sorting
and Filters".
Description of metadata
Metadata Description
- The listed lines already stored in the job.
Closed The status of a line.
If a line is closed, it me
ans that it is physically closed onto
itself, effectively becoming an area.
Next step
Page
until the 3D viewer page is active.
For information on camera and images refer to "32.4 Image Management".
Check one or multiple scans for a perspective display of the 3D point clouds in
the 3D view
er
. Use Fn All to select all scans at once.
Key Description
OK To close the panel and return to the panel from where this
panel was ac
c
essed.
Page To change to another page on this panel.
Fn Delete To delete the highlighted scan.
Fn All or
Fn None
To select or deselect all scans at once.
Description of metadata
Inf
ormation about the date, the time, the status and the number points.
7.3 Point Management
7.3.1 Creating a New Point
In Job name
, Points page, press New.
☞
Job name,
Sc
ans page
Access
Job M
enu - View & edit data 79
To Next Page