Field Option Description
Cut slope
and
Fill slope
E
ditable field Defines the cut/fill ratio of the slope.
☞
The slope ratio format is defined
as system setting in Regional,
Slope page.
45.4.11 Manual Slope
This function is available for stake/check of slopes.
To access Slope Definit
ion. Allows a manual slope to be defined. The defined
manual slope is then used for all points to stake out or check. Refer to "Slope
Definition"for a description of the panel.
☞
The manual slope is active until it is turned off with Rese
t slope to
design from the toolbox.
45.4.12 Reset slope to design
This function is available for stake/check of slopes.
This option is only available if a slope has been defined by using Ge
t current
slope. The manually defined slope is deactivated and reset to the design
slope.
45.4.13 Shift reference line
This menu function is available for the stake/check of slopes and surface
grade
s.
The Shift reference line item of the toolbox stays disabled until the first
measured position is available. The current chainage is used for the cross sec-
tion shown to pick the reference line.
When staking out or checking different layers of the road strata, such as the
subgrade, gr
avel or asphalt, it is often found that not all these layers are avail-
able in the design. For such cases, the app offers the possibility to apply either
a negative or positive height shift to the design values.
Example
A grav
el layer with a thickness of 10 cm for stakeout. A negative vertical shift
to the final design surface is applied. This shift is applied:
•
by pressing Shifts in the Define panel and
•
by applying a vertical shift of -10 cm.
As shown, the selected surface grade is shifted by 10 cm.
a Reference surface
b Shif
ted reference point
c Original surface grade
d Shifted surface grade
Availability
Description
Availability
Description
Availability
Description
780 Roads - Road
To Next Page