Key Description
Fn Indiv ID
and
Fn
Run
To change between entering an individual point ID different
to the defined ID template and the running point ID accord-
ing to the ID template. Refer to "26.3 ID templates".
Description of fields
Field Option Description
Point ID Editable field Displays the point ID for the remote point.
The p
oint ID in Measure Remote Point is
always identical to the point ID in Measure.
Difference
in height
from
remote
point to
base point
Display only The elevation difference between the base
point and the remote point.
Hz Display only The current horizontal angle.
V Display only The current vertical angle.
Slope dis-
tance
Display only The current slope distance to the remote
point calculated from the horizontal distance
to the base point and the current vertical
angle.
Horizontal
distance
Display only The horizontal distance measured to the
base point.
Easting Display only Calculated Easting coordinate for the remote
point.
Northing Display only Calculated Northing coordinate for the
remote point.
Height Display only Calculated height for the remote point.
Next step
IF THEN
a remote point must be stored Store.
a new base point must be measured Base pt t
o return to the Measure
ap
p.
a code must be added change to the Code page.
37.4.3 Configuring Remote Point
In Remote points press Fn Settings to access Remote points.Access
Apps - The Toolbox 435
To Next Page