If staking local grid points with GNSS, always ensure that the correct coordi-
nat
e system is being used. For example, if the points to be staked are stored in
WGS 1984, the active coordinate system must also be WGS 1984.
It is possible to stake:
•
P
ositio
n only points.
•
Height only points.
•
Points with full sets of coordinates.
Height type of the point to be
stak
ed:
Orthometric OR ellipsoidal
Height type computed for current
position:
Orthometric OR ellipsoidal depend-
ing on the
•
configured transformation,
•
availability of a geoid model,
•
height type of the point to be
staked.
If possible, the height type of the
point to be staked is computed for
the current position.
Heights can be taken into account from
•
the v
er
tical component of a coordinate triplet.
•
a Digital Terrain Model.
The DTM licence key must be loaded. Refer to "29.3 Load licence keys" for
inf
ormation on how to enter the licence key.
If loaded, the height of the points to be staked can be edited in the field.
Codes can be attached to staked points. The behaviour of the coding function-
ality dep
ends o
n the definition of a page with editable fields for coding and
attributes.
The principles for averaging are identical to the averaging principles of the
Measur
e app.
51.2 Accessing Stakeout
Select Leica Cap
tivate - Home: Stake points.
The points to be staked are stored in the selected design job.
Poin
ts which are measured during staking out are stored in the selected job.
51.3 Configuring Stakeout
Select Leica Cap
tivate - Home: Stake points. Press Fn Settings.
Coordinate system
Point types
Height types
Height source
Coding of staked
p
oin
ts
Averaging of staked
poin
ts
Access
☞
Access
894 Stakeout
To Next Page