Leica Captivate - For GS Points; For TS Point; For TS Points Measured with Measure Foresight

Next step
Page
changes to the next page.
Available when the edited point is Class: Measur
ed.
For GS points
The name o
f the real-time base station from where the GNSS point was meas-
ured, the name of antenna used to measure the point and the baseline values,
are shown in display only/observations fields.
For TS point
It is possible to edit the reflector height. The name of the setup from where
the point was measured is shown in a display only field.
☞
Changing the reflector height recalculates the point height. The values
for Cut and Fill in Stake results page are also updated.
The distance variables Difference in Hz angle, Difference in V angle, Dif-
ference in slope distance are shown in a display only field, whenever a
measurement has been taken in both faces.
More displays the horizontal angle or the azimuth from the point to the instru-
ment.
For TS points measured with Measure Foresight
List
ed are the setup ID, the backsight point, the set number and the average
measurement values.
☞
Press Sets to include or exclude measured sets in the calculation of a
foresight point.
Next step
Page
changes to the next page.
Available when the edited point was measured with offsets using TS.
Check and change, if required, the entered offset values. When an offset values
has been changed, the c
oordinates for the stored point will be updated.
Key Description
Store To store the changes.
Page To change to another page on this panel.
Description of fields
Field Option Description
Offset left/
right
The cross offset of the target point, perpen-
dicular to the line of sight.
Display only For staked points.
Point ID,
Obs page
Point ID,
Offse
t page
84 Job M
enu - View & edit data