Key Description
Fn Ell Ht or
Fn
Height
Available for local coordinates. Changes between the ellip-
soidal and the orthometric height. Changing the height
type does not edit the point.
Next step
Page
changes to the next page.
On this page, the stakeout results are displayed.
☞
When changing Targe
t height on the Obs page, the Measured
height value is updated. The offset values used for staking the point
will not be editable on the Offset page.
Key Description
Store To store the changes.
Page To change to another page on this panel.
Description of fields
Field Option Description
Design
poin
t ID
Display only The name of the design point that was
staked.
Difference
in easting
Display only The difference between the Design easting
and the Measured easting.
Difference
in northing
Display only The difference between the Design north-
ing and the Measured northing.
Cut/Fill Display only The height difference between the Design
height and the Measured height.
2D distance Display only Displays the horizontal difference between
the design point and the staked point.
3D distance Display only Displays the spatial difference between the
design point and the staked point.
Design east-
ing
Display only The entered design Easting.
Design
northing
Display only The entered design Northing.
Design
height
Display only The entered design elevation.
Measured
easting
Display only The Easting measured at the stored point.
Measured
northing
Display only The Northing measured at the stored point.
Measured
height
Display only The height measured at the stored point.
Point ID,
St
ake results page
Job Menu - View & edit data 83
To Next Page