Description of fields
Field Option Description
Use points
& lines da
ta
Check box When this box is checked, a separate design
job can be selected. Target points can be
selected from the design job. Individual lines
and/or points of a separate design job can
be staked out.
The selected design job is visible in 3D
viewer.
Name Selectable list Control points or lines are stored in the
design job. The design job holds all control
point information needed in the field, for
example, control points, points with known
coordinates used for a TS setup. Lines of the
design job can be used for Stake to line or
Measure to line.
A CAD file attached to a design job can be
used to view and import the CAD lines for
working with.
Description Display only The detailed description of the job.
Date cre-
ated
Display only The date of when the job was created.
Last used Display only The date of when the job was last accessed.
Use a DTM Check box When this box is checked, a DTM job can be
selected. A DTM job holds DTM (Digital Ter-
rain Model) or TIN (Triangular Irregular Net-
work) data. The files are stored in the \DBX
folder or a subfolder of \DBX.
DTM Selectable list Holds DTM (Digital Terrain Model) data or
TIN (Triangular Irregular Network) data. The
DTM job to be used must be stored in the
\DBX directory on the active data storage
device.
The DTM job is a read-only source of infor-
mation and cannot be selected as a job.
☞
The selected DTM job is visible in
the 3D viewer.
Layer Display only
or selectable
list
A DTM job can consist of multiple DTM layers
or surfaces. These DTM layers can cover dif-
ferent locations, be on top of each other or
intersect each other.
If there is only one layer in the DTM job, the
layer name is displayed as an output. If there
are multiple layers, the layer to display in 3D
viewer can be selected.
Job Menu - Jobs 63
To Next Page