Next step
Page
changes to the Coords page. This page displays the design coordinates
as well as the differences between design and measured coordinates.
Page changes to the Code page where codes can be selected or typed in.
Page changes to the Elevations page.
On this page, multiple elevations can be stored to one staked point.
Example
When me
asuring the centre of a manhole, the drain below may have pipelines
joining at different height levels. To store and stakeout these pipeline inverts,
additional heights can be entered. The cut and fill value will automatically be
calculated, allowing to transfer this information to the stake marker.
Key Description
OK To return to the stake panel. To store all values.
Last To recall the last stored elevations and information.
Page To change to another page on this panel.
Description of fields
Field Option Description
Elevation Editable field The entered elevation is stored with the
poin
t and used to calculate the cut and fill
values.
Cut/Fill Display only Height of the point being stored
– Entered elevation
-----------------------------------------
= Cut or fill value (always positive)
Examples
For cut:
Height of the point being stored
– Entered elevation
-----------------------------------------
Result > 0
598.5672 m – 596.4856 m = 2.0816 m = cut
The displayed value is 2.0816 m.
For fill:
Height of the point being stored
– Entered elevation
-----------------------------------------
Result < 0
598.5672 m – 599.7826 m = -1.2154 m = fill
The displayed value is 1.2154 m.
Stake Results,
Elevat
ions page
906 Stakeout
To Next Page