2-8 Service Manual
5062
201.03 Bubble sensor is never made or is
made late.
Possible causes:
• Faulty bubble sensor
• Faulty fuser connection
• Clear away anything in the paper path that might
cause the paper to jam.
• If clearing a paper jam does not fix the problem,
go to “201.03, 201.05, 201.07, 201.08—Paper
Jam error service check” on page 2-90.
201.04 Bubble sensor broke early.
Possible causes:
• Incorrect paper settings
• Defective bubble sensor
• Faulty system board
• Clear away anything in the paper path that might
cause the paper to jam.
• Be sure the paper settings match the media.
•Go to “121.xx—Fuser error service check” on
page 2-60.
201.05,
201.07,
201.08
Bubble sensor is never made or is
made late.
See “201.03” on page 2-8.
201.42 A narrow banner media error has
occurred.
• Clear away anything in the paper path that might
cause the paper to jam.
• If clearing a paper jam does not fix the problem,
go to “Input, S1, narrow media, and near
narrow media sensor service check” on
page 2-121.
201.51 Bubble sensor active when printer
powers up or a cover is closed.
(Fuser past life)
See “201.01” on page 2-7.
201.52 Bubble sensor is made early.
(Fuser past life)
See “201.02” on page 2-7.
201.53 Bubble sensor is never made or is
made late.
(Fuser past life)
See “201.03” on page 2-8.
201.54 Bubble sensor broke early.
(Fuser past life)
See “201.04” on page 2-8.
201.55,
201.57,
201.58
Bubble sensor is never made or is
made late.
(Fuser past life)
See “201.03” on page 2-8.
Error code Description Action
To Next Page
Loading...
