Lexmark C935 - Page 103

Diagnostic information 2-11
5057-XXX
Go Back
Previous
Next
904.05
Service
transfer belt
Sensor (CMY transfer roll
retract HP) late error
The sensing area of the sensor (CMY transfer roll
retract HP) is not interrupted within the specified
time when the CMY transfer rolls is moving to the
home position.
Go to “904.05 Sensor (CMY transfer roll retract
HP) late error” on page 2-88
904.06
Service
transfer belt
Sensor (CMY transfer roll
retract HP) lag
The sensing area of the sensor (CMY transfer roll
retract HP) remains interrupted within the specified
time when the 2nd transfer roll is moving from the
home position.
Go to “904.06 Sensor (CMY transfer roll retract
HP) lag error” on page 2-91.
904.07
Service
transfer belt
CMY transfer roll retract
motor time out
The CMY transfer roll retract motor has failed.
Go to “904.07 CMY transfer roll retract motor
time out” on page 2-93.
905.00
Service engine
error
NVM read/write cannot be
executed error
Engine NVM read/write has failed.
Go to “905.00 NVM read/write cannot be
executed error” on page 2-94.
905.01
Service engine
error
Marking device video error Internal processing error occurred in printer engine.
Go to “905.01 Marking device video error” on
page 2-94.
905.02
Service engine
error
Marking device Xerographic
error
Internal processing error occurred in printer engine.
Go to “905.02 Marking device Xerographics
error” on page 2-95.
905.03
Service engine
error
Marking device other1 error Internal processing error occurred in printer engine.
Go to “905.03 Marking device other1 error” on
page 2-95.
905.04
Service engine
error
Marking device paper
handling error
Internal processing error occurred in printer engine.
Go to “905.04 Marking device paper handling
error” on page 2-95.
905.05
Service engine
error
Marking device other2 error Internal processing error occurred in printer engine.
Go to “905.05 Marking device other2 error” on
page 2-95.
907.00
Printhead error
Printhead polygon mirror
motor error
The printhead polygon mirror motor has failed or
does not rotate at the specified speed.
Go to “907.00 Printhead polygon mirror motor
error” on page 2-96
907.01
Printhead error
Y laser SOS internal error The interval of the printhead start of scan Y signals
exceed the specified value.
Go to “907.01 Y laser SOS internal error” on
page 2-96.
907.02
Printhead error
M laser SOS internal error The interval of the printhead start of scan M signals
exceed the specified value.
Go to “907.02 C laser SOS internal error” on
page 2-96.
Error code or
message
Error contents Description/Action