Lexmark C935 - Page 347

Repair information 4-49
5057-XXX
Go Back
Previous
Next
Warning: When removing the CMY toner add assemblies, the toner cartridges should be left installed in order
to reduce toner spillage.
7. Remove the three CMY toner add assemblies. See “CMY toner add assembly removal” on page 4-46.
Warning: When removing the K toner add assembly, the toner cartridge should be left installed in order to
reduce toner spillage.
8. Remove the K toner add assembly. See “K toner add assembly removal” on page 4-48.
9. Remove the harnesses from the clamps on the developer interlock plate assembly (A).
Warning: Use extreme caution when disconnecting the next seven connectors from the upper harness strip, or
damage will occur.
10. Disconnect the seven connectors from the upper harness strip.
11. Remove the four developer harnesses from the four clamps on the developer interlock plate assembly (A).
12. Remove the six screws securing the developer interlock plate assembly (A) to the machine.
13. Remove the purple harness from the large black plastic clamp on the developer interlock plate assembly (A)