Repair information 4-65
5057-XXX
13. Remove the plastic cover (A).
14. Remove the transfer belt lift handle assembly. See “Transfer belt lift handle assembly removal” on
page 4-70.
15. Remove the waste toner agitator motor assembly. See “Waste toner agitator motor assembly removal” on
page 4-43.
Note: Ensure that the left transfer belt lift assembly is in the up position in order to remove the image density
sensor assembly.
16. Remove the image density sensor assembly. See “Image density sensor assembly removal” on
page 4-44.
17. Remove the K erase lamp assembly. “K erase lamp assembly removal” on page 4-77.
18. Removed the two screws securing the bracket (A) to the machine.
To Next Page
Loading...
