Repair information 4-67
5057-XXX
21. Remove the two screws from the left transfer belt lift assembly (B).
Note: In order to remove the left transfer belt lift assembly (B), two E-clips and two washers must be
removed. The two E-clips and two washers are located inside the machine in the area where the K PC unit is
located.
Warning: Do not loose the two E-clips, four washers, and two bearings. The need to be installed on the new
left transfer belt lift assembly (B) being installed in the machine.
22. Remove the two E-clips and the two washers securing the left transfer belt lift assembly (B) to the machine.
To Next Page
Loading...
