Repair information 4-227
5057-XXX
2
Perform the center setup:
1. Enter the Diagnostics Menu.
2. Select ENGINE ADJUST.
3. Select RegCon adjust
4. Select Control setup cycles
5. Select Center setup
Does the above test pass?
Move the image
density sensor
back to its original
position.
The color
registration
(RegCon)
procedure is now
complete.
Go to step 3.
3
The image density sensor is not properly set in the center
position. Ensure the image density is placed in the center
position.
Is the image density placed in the center position.
Go to step 2. Repeat step 3.
Step Check Yes No
To Next Page
Loading...
