Lexmark X792 - XX-Fuser Error Service Check

Diagnostic information 2-79
7562
Go Back
Previous
Next
121.xx—Fuser error service check
5
Replace the fuser motor. See “Fuser drive
assembly removal” on page 4-61.
Does the problem reoccur?
Replace the system board.
See “System board
removal” on page 4-149.
Problem solved.
Step Questions / actions Yes No
1 Replace the fuser. See “Fuser assembly
removal” on page 4-60.
Does the error clear?
Problem solved. Go to step 2.
2
Open the system board shield. Check the
cable in connector JFSR1 (D) for proper
connection to the system board.
Is the cable properly connected?
Go to step 3. Reseat the cable.
3
Check the cable for damage.
Is the cable damaged?
Replace the Fuser and
system card LVPS cable.
See “Fuser system card
and LVPS cable removal”
on page 4-63.
Go to step 4.
Step Questions / actions Yes No
D