Repair information 4-95
7562
MPF breakaway assemblies removal
See “Left” on page 7-11 for the part numbers.
1. Remove the rear cover. See “Rear cover removal” on page 4-23.
2. Remove the standard media tray. See “Standard media tray removal” on page 4-148.
3. Gently lay the printer on its back.
4. Remove the screw (88A0212) from the LVPS.
5. Remove seven screws (A) and two screws (B), and remove the bottom plate.
Note: If you are replacing the input option cable, then push it up through the frame, and then stand the
printer back up to remove the cable.
A (88A0323)
B (10J1046)
B (10J1046)
To Next Page
Loading...
