Lexmark X792 - Paper Jams

2-22 Service Manual
7562
Go Back
Previous
Next
280–289 paper jams
An ADF maintenance kit is available if the printer is experiencing scan image quality issues such as streaking,
gray images in the same place on flatbed scans, in addition to the paper feed issues listed in the checks below.
1. Remove all original documents from the ADF.
2. Open the ADF door.
3. Grasp the jammed paper on both side, and then gently pull it out.
Note: Make sure all paper fragments are removed.
4. Close the ADF door.
5. Flex and stack the original documents.
6. Reload the original documents into the ADF, and then adjust the paper guide.
7. From the operator panel, touch Continue.
Additional checks—280–289 paper jams
Error code Description Action
280.06 Paper missing. 1. Remove all media present in the media path.
2. Check the ADF input sensor for proper
operation. Go to “280.06—Media missing jam
service check” on page 2-125.
282.01 Scanner Static Jam—ADF skew
sensor
1. Remove all media present in media path.
2. Check the ADF skew sensor for proper
operation. Go to “282.01—Sensor (ADF sheet
through) static jam service check” on
page 2-126.
282.03 Scanner Static Jam—ADF pickup jam 1. Remove all media present in the media path.
2. Check for obstructions in the media path.
3. If the problem persists, go to “282.03—Sensor
(ADF sheet through) late jam service check”
on page 2-126.