4-314 Service Manual
7562
5-bin mailbox cave beacon removal
See “5-bin mailbox assembly (interior)” on page 7-49 for the part number.
1. Remove the mailbox from the printer.
2. Remove the three screws (A) from the bottom to remove the cable cover.
3. Remove the screw (C), and then disconnect the cable (B) from the card to remove the beacon.
Note: Observe the cable routing for reinstallation. To replace the cable, remove the rear cover and
disconnect the cable from the printer circuit board. See “5-bin mailbox rear cover removal” on
page 4-327.
To Next Page
Loading...
