Repair information 4-137
7562
Sensor (input, S1, narrow media, near narrow media) removal
See “Left” on page 7-10 for the part number.
1. Remove the staging deflector assembly. See “Staging deflector assembly removal” on page 4-138.
2. Locate the sensor you need to replace: input (A), S1 (B), narrow media (C), near narrow media (D).
3. Remove the sensor retainer (E), and then press the tabs to release the sensor.
4. Disconnect the sensor cable to remove the sensor.
Installation note: Reinstall a sensor retainer after you attach the new sensor.
To Next Page
Loading...
