Lexmark X792 - ADF Skew Adjustment (Duplex CCD Assembly)

Diagnostic aids 3-63
7562
Go Back
Previous
Next
ADF skew adjustment (duplex CCD assembly)
1.
Open the ADF top door.
2. Remove two screws (A) from the top of the front ADF cover.
3. Lift the ADF unit assembly, and remove one screw (B) from the bottom of the cover.
4. Release the bottom tabs (C) to remove the cover.
5. Close the ADF, and adjust skew for the ADF front:
a. Loosen the screw (F), and slide it slightly to the left.
b. Reinstall the ADF cover, and make a copy to check the skew. Repeat the steps as needed.
C
B
A