Lexmark X792 - Media Missing Jam Service Check

Diagnostic information 2-125
7562
Go Back
Previous
Next
280.06—Media missing jam service check
Step Check Yes No
1 1. Remove all documents from the ADF.
2. Place an undamaged document in the
ADF, and perform a ADF test.
Does the error remain?
Go to step 2. Problem solved.
2
Check the sensor (ADF document set) for
proper operation.
1. Enter the Diagnostics Menu.
2. Touch SCANNER TESTS.
3. Touch Sensor Tests.
4. Touch TBD.
Does the display on the operator panel,
change every time the sensing area of the
above sensor is interrupted or blocked?
Go to step 6. Go to step 5.
3
Check the sensor (2nd scan) for proper
connection.
Is the above component properly
connected?
Replace the sensor (ADF
document set). See
“Sensor (ADF document
set) removal” on
page 4-206.
Replace the connection.
4
Place an undamaged document in the ADF,
and perform an ADF test.
Does the error remain?
Replace the ADF controller
card assembly. See “ADF
controller card removal”
on page 4-174.
Go to step 5.
Problem solved.
5
Perform a print test using the ADF.
Does the problem persists?
Contact your next level of
support.
Problem solved.