2-128 Service Manual
7562
283.01—Sensor (1st scan) static jam service check
Step Check Yes No
1 Check the media path.
Is the media path free of media or media
fragments?
Go to step 2. Remove any media or
media fragments.
2
Check the sensor (ADF 1st scan) for proper
operation.
1. Enter the Diagnostics Menu.
2. Touch SCANNER TESTS.
3. Touch Sensor Tests.
4. Observe the line “sensor (ADF 1st can)”.
Does the display on the operator panel,
change every time the sensing area of the
above sensor is interrupted or blocked?
Go to step 4. Go to step 3.
3
Check the sensor (ADF 1st scan) for proper
connection.
Is the above component properly
connected?
Replace the sensor (ADF
1st scan). See “Sensor
(ADF 1st scan) removal”
on page 4-205.
Replace the connection.
4
Place an undamaged document in the ADF,
and perform a ADF test.
Does the error remain?
Replace the ADF controller
card assembly.
See “ADF controller card
removal” on page 4-174.
Go to step 5.
Problem solved.
5
Perform a print test using the ADF.
Does the problem remain?
Contact your next level of
support.
Problem solved.
To Next Page
Loading...
