Lexmark X792 - XX-Staging Motor Error Service Check

2-96 Service Manual
7562
Go Back
Previous
Next
147.xx—Staging motor error service check
Step Questions / actions Yes No
1 Turn the printer off, and open the system
board shield. Check the cable in connector
JSTAG1 for proper connection to the system
board.
Is the cable properly connected?
Go to step 2. Reseat the cable.
2
Check the cable for damage.
Is the cable damaged?
Replace the cable. See
“Staging paper path
reference edge assembly
removal” on page 4-140
to access the cable.
Go to step 3.
3
Remove the LVPS. See “Low-voltage
power supply (LVPS) removal” on
page 4-81. Check the cable connection to the
motor.
Is the cable connected correctly to the
staging motor?
Go to step 4. Reseat the cable.
4
Replace the staging paper path reference
edge assembly. See “Staging paper path
reference edge assembly removal” on
page 4-140.
Dose the error reoccur?
Replace the system board.
See “System board
removal” on page 4-149.
Problem solved.