Lexmark X792 - Bin-Full Sensor Service Check

Diagnostic information 2-169
7562
Go Back
Previous
Next
Bin-full sensor service check
8
Replace the 2000-sheet high-capacity feeder
pick assembly. See “2000-sheet high-
capacity feeder pick assembly removal”
on page 4-295.
Does the problem persist?
Go to step 9. Problem solved.
9
Replace the 2000-sheet high-capacity feeder
drive assembly. See “2000-sheet high-
capacity feeder drive assembly removal”
on page 4-261.
Does the problem persist?
Go to step 10. Problem solved.
10
Replace the 2000-sheet high-capacity feeder
controller card assembly. See “2000-sheet
high-capacity feeder controller card
assembly removal” on page 4-260.
Does the problem persist?
Replace the 2000-sheet
high-capacity feeder input
option.
Problem solved.
Step Questions / actions Yes No
1 Is the bin-full flag damaged? Replace the bin-full flag.
See “Bin-full flag
removal” on page 4-33.
Go to step 2.
2
Turn the printer off, and open the system
board shield. Check the cable in connector
JTCVR1 for proper connection to the system
board.
Is the cable properly connected?
Go to step 3. Reseat the cable.
3
Check the cable in connector JTCVR1 for
damage.
Is the cable damaged?
Replace the bin-full and
output beacon cable.
To access the cable, see
“AIO top cover removal”
on page 4-5.
Go to step 4.
Step Questions / actions Yes No