Lexmark X792 - Beacons Test; USB HS Test Mode

Diagnostic aids 3-17
7562
Go Back
Previous
Next
Break Interrupt Error
Framing Error
Parity Error
Overrun Error
Data Error
Data 232 Error
Data 422 Error
FIFO Error
DSR Error
DSR PIO Error
DSR Interrupt Error
CTS Error
CTS PIO Error
CTS Interrupt Error
Once the maximum count is reached or a failure occurs, the test stops.
Press Stop (
X) to cancel the test.
USB HS Test Mode
If the test fails, replace the failing USB cable.
1. From the Diagnostics menu, navigate to:
HARDWARE TESTS > USB HS Test Mode
2. Select the desired Port.
3. Select the desired Test.
To cancel the test, turn the printer off.
Beacons Test
Select On to turn on all printer beacons. The beacons remain on until you select Off.
Ports Tests
Port 0
Port 1
Port 2
Port 3
Test J
Test K
Test SEO NAK
Test Packet
Test Force Enable