Lexmark X792 - Finisher or Stacker Top Cover Removal

Repair information 4-359
7562
Go Back
Previous
Next
Finisher or stacker top cover removal
See “Finisher /High-capacity output stacker assembly” on page 7-37 for the part number.
1. Remove the option from the printer.
2. Remove the front cover. See “Finisher or stacker front cover removal” on page 4-337.
3. Remove the rear cover. See “Finisher or stacker rear cover removal” on page 4-346.
4. Remove the screw (A) on each side of the top cover.
5. Open the left access door, and use a screwdriver to force the rear hinge (B) out of the slot by pushing the
door to the front.