Lexmark X792 - Finisher Sensor (Stapler Access Door Interlock) Removal; Finisher or Stacker Sensor (Pass Thru) Removal

4-352 Service Manual
7562
Go Back
Previous
Next
Finisher sensor (stapler access door interlock) removal
1. Remove the finisher from the printer.
2. Remove the finisher rear cover. See “Finisher or stacker rear cover removal” on page 4-346.
3. Disconnect the cable from the sensor.
4. Pinch tab to remove the sensor.
Finisher or stacker sensor (pass thru) removal
See “Finisher /High-capacity output stacker assembly” on page 7-37 for the part number.
1. Remove the finisher from the printer.
2. Remove the finisher rear cover. See “Finisher or stacker rear cover removal” on page 4-346.
3. Remove the finisher front cover. See “Finisher or stacker front cover removal” on page 4-337.
4. Open the left access door, and pry out the left hinge (A) to lower the door.
5. Push the door to the right to release the left hinge, and then release the right hinge.