Lexmark X792 - UI Automation; Key Repeat Initial Delay; Key Repeat Rate; Clear Custom Status

Diagnostic aids 3-35
7562
Go Back
Previous
Next
UI Automation
Once enabled, this setting creates an “ENABLE_UI_AUTOMATION” file in the shared directory. As long as this
file exists, the printer permits external developers to test the stability of their applications against the printer to
ensure that their applications have an appropriate level of stability. Disabling this setting deletes the file.
Key Repeat Initial Delay
This setting determines the length of delay before a repeating key starts repeating. The default setting is 1
second. You can adjust the setting by .25 second increments.
Key Repeat Rate
This setting indicates the number of presses per second for repeating keys. The default setting is 15 presses per
second.
Clear Custom Status
This setting erases any custom messages the user has created for the Default or Alternate custom messages.
USB Speed
This setting determines the speed at which the USB port reads and writes data from flash drives. Auto is the
default setting. Setting the USB Speed to Full disables the high-speed capabilities of the port.
Exit Config Menu
Press Select to exit the Configuration menu and reboot the printer.