Lexmark X792 - 5-Bin Mailbox Feed Motor with Plate Removal

4-318 Service Manual
7562
Go Back
Previous
Next
5-bin mailbox feed motor with plate removal
See “5-bin mailbox assembly (interior)” on page 7-49 for the part number.
1. Remove the mailbox from the printer.
2. Remove the mailbox front cover. See “5-bin mailbox front cover removal” on page 4-319.
3. Remove the printer circuit board. See “5-bin mailbox controller card removal” on page 4-315.
4. Remove four screws (A), and remove the feed motor side plate.
5. Squeeze the tabs and push up to release the option connector, and then slide the plate over the cable to
remove it.