Repair information 4-357
7562
Finisher or stacker tamper drive motor assembly removal
See “Finisher/High-capacity output stacker assembly (continued)” on page 7-39 for the part number.
Note: The left tamper motor controls the front tamper, and the right tamper motor controls the rear tamper.
1. Remove the option from the printer.
2. Remove the top cover. See “Finisher or stacker top cover removal” on page 4-359.
3. From the controller card, disconnect the cable for the motor you are removing: left motor (A); right motor
(B).
4. Disconnect the cable wrapped around the motor cables (C) to free the motor cable.
5. Clip the cable tie (D).
6. Use a spring hook to remove the tamper recoil spring (E) for the motor you are removing.
7. Remove the two screws (F) from the motor you are removing, and remove the motor assembly.
To Next Page
Loading...
