3-60 Service Manual
7562
7. Adjust the copy skew based on the type of adjustment to use listed on the table.
Adjusting scanner registration
Before adjusting skew, be sure the scanner registration is within acceptable parameters.
Note: If the printer menus do not match the following instructions, then contact your next level of support.
1. Enter the Configuration menu: press and hold 2 and 6, turn on the printer, and release the buttons when
the splash screen appears.
2. Navigate to:
Scanner Manual Registration > Print Quick Test
3. Adjust the flatbed:
a. Place the printed test page facedown on the flatbed scanner glass, and select Copy Quick Test.
b. Compare the copy to the original test page.
c. Select Flatbed, and adjust the left and top margins as needed.
d. Touch Submit to save your changes.
e. To check the changes, reload the original test page, and then repeat the Copy Quick Test. Repeat
the steps as needed.
4. Adjust the ADF Front:
a. Place the latest test page faceup in the ADF, and select Copy Quick Test.
b. Compare the copy to the original test page.
c. Select ADF Front, and adjust the horizontal adjust and top margins as needed.
d. Touch Submit to save your changes.
e. To check the changes, reload the original test page, and then repeat the Copy Quick Test. Repeat
the steps as needed.
5. Adjust the ADF Back:
a. Place the latest test page facedown in the ADF, and select Copy Quick Test.
b. Compare the copy to the original test page.
c. Select ADF Back, and adjust the horizontal adjust and top margins as needed.
d. Touch Submit to save your changes.
e. To check the changes, reload the original test page, and then repeat the Copy Quick Test. Repeat
the steps as needed.
6. Touch Back to return to the Configuration Menu.
Copy Type Adjustment
Flatbed Copy Go to “Flatbed scanner skew adjustment” on page 3-61.
Front Side ADF Copy Go to “Flatbed scanner skew adjustment” on page 3-61 and “ADF
skew adjustment (ADF document tray)” on page 3-64.
Back Side ADF Copy Go to “ADF skew adjustment (ADF document tray)” on page 3-64 and
“ADF skew adjustment (duplex CCD assembly)” on page 3-63.
To Next Page
Loading...
