Lexmark X792 - 461.08-Hole Punch Sensor Error Service Check

Diagnostic information 2-149
7562
Go Back
Previous
Next
461.01 - 461.08—Hole punch sensor error service check
Step Questions / actions Yes No
1 1. Bring the printer up in Diagnostics menu (turn off the
printer, press and hold 3 and 6, turn on the printer,
and hold the buttons until the splash screen appears).
2. Navigate to INPUT TRAY TESTS > Feed Test.
3. Select Tray 1.
4. Select Single.
Does the error reoccur?
Go to step 2. Problem solved.
2
1. Remove the HTU rear standard bin cover. See “HTU
rear standard bin cover removal” on page 4-394.
2. Check the cable in the indicated connector.
Is the cable properly connected?
Go to step 3. Reseat the
cable.
3
Replace the punch unit. See “HTU punch unit removal”
on page 4-418.
Does the error reoccur?
Replace the
HTU controller
card. See “HTU
controller card
removal” on
page 4-369.
Problem solved.