Parts catalog 7-71
7562
Screw and retainer identification table
The following table contains screw and fastener descriptions, locations, and quantities necessary to service the
printer. Pay careful attention to each screw type location when doing removals. You must install the correct
screw type in each location during reassembly.
Sizes are as close to actual as possible, as long as the printout is not scaled or resized.
Screw identification table
P/N Screw type Location Qty
10B1580 #6 1.75” Panhead Main fan to exit cooling fan duct 2
LVPS fan to LVPS exit duct 2
10J1046 3 x 5 mm Pads to bottom plate 6
Bottom plate to cartridge rails 2
10J1733 M3.5 x 10 mm
Flathead
ITU DS roller plate to paper path staging assembly 2
10J3568 SEMS Machine
Panhead
Printhead brackets to frame 6
27S2839 Taptite M3 x 6 mm
slotted hex black
System board shield to system board cage 6
To Next Page
Loading...
