Lexmark X792 - ADF Separator Torque Limiter Assembly Removal

Repair information 4-195
7562
Go Back
Previous
Next
3. Lift the tab (A), and slide the separator roll off the shaft.
Installation note: After sliding the separator roll onto the shaft, twist it until it fits into the grooves on to the torque
limiter.
ADF separator torque limiter assembly removal
See “ADF feed and drive” on page 7-25 for the part number.
1. Remove the ADF separator roll. See “ADF separator roll removal” on page 4-194.
2. Slide the ADF separator torque limiter assembly off the shaft.
A