4-2 Service Manual
7562
Removal procedures
Cable ties
Note: Some removal procedures require removing cable ties. You must replace cable ties during reassembly to
avoid pinching wires, obstructing the paper path, or restricting mechanical movement.
Cable and thermistor removals
For a complete list of the printer cable and thermistor FRUs and links to the removal procedures used to access
them, see “Cable and thermistor location table” on page 7-67.
Screws and fasteners
Screw and fastener part numbers appear with the graphic callouts. See “Screw and retainer identification
table” on page 7-71 for descriptions and actual-size illustrations of the screws.
Arrangement of removals in this chapter
The removals in this chapter are arranged by area of the printer:
“Base printer cover removals” on page 4-3
“Base printer removals” on page 4-33
“ADF cover removals” on page 4-170
“ADF removals” on page 4-173
“Scanner cover removals” on page 4-211
“Scanner removals” on page 4-217
“Input option removals” on page 4-239
“Output option removals” on page 4-310
CAUTION
For personal safety and to prevent damage to the printer, remove the power cord from the
electrical outlet before you connect or disconnect any cable or electronic board or assembly.
Disconnect any connections between the printer and PCs/peripherals.
CAUTION
The printer weight is greater than 32 kg (70 lb) and requires three or more trained personnel
to move it safely.
To Next Page
Loading...
