Repair information 4-345
7562
Finisher or stacker paddle drive motor assembly removal
See “Finisher/High-capacity output stacker assembly (continued)” on page 7-39 for the part number.
1. Remove the option from the printer.
2. Remove the front cover. See “Finisher or stacker front cover removal” on page 4-337.
3. Disconnect the paddle motor cable from the controller card.
4. Remove the cable from the clip.
5. Remove the three screws (A) securing the two paddle drive motor assemblies.
6. Remove the paddle drive motor assembly.
Installation note: Be sure to line up the locator (B) when you install the motor.
To Next Page
Loading...
