Lexmark X792 - Flatbed Scanner CCD Assembly Removal

Repair information 4-221
7562
Go Back
Previous
Next
Flatbed scanner CCD assembly removal
See “Flatbed scanner” on page 7-19 for the part number.
1. Remove the scanner platen glass cover. See “Scanner platen glass cover removal” on page 4-234.
2. Loosen the screw (A) in the tensioner.
3. Pull the tensioner all the way to the right to put slack in the belt, and then retighten the screw.
4. Slide the belt off the tensioner.
5. From the left side of the printer, lift the end of the rear CCD scanner shaft (B), and slide it out of the printer.
6. Pull the belt out of the clip on the scanner CCD assembly.
7. Turn the assembly upside down and carefully disconnect the ribbon cable to remove the assembly.
Installation note: After replacing the flatbed scanner CCD assembly, you must calibrate the scanner and
check for skew. See “Calibrating the scanner” on page 3-67, “Adjusting skew” on page 3-54.
A
B