Lexmark X792 - XX-Black Cartridge Motor Error Service Check

Diagnostic information 2-89
7562
Go Back
Previous
Next
141.xx—Black cartridge motor error service check
Step Questions / actions Yes No
1 Turn the printer off, open the system board
shield, and remove the RIP card shield.
Check the cable in the connector JKI1 for
proper connection to the system board.
Is the cable properly connected?
Go to step 2. Reseat the cable.
2
Check the cable for damage.
Is the cable damaged?
Replace the BLDC K ITU
cable. See “EP drive
assembly removal” on
page 4-54.
Go to step 3.
3
Measure the resistance across the fuse F10
on the system board.
Is the fuse blown?
Replace the system board.
See “System board
removal” on page 4-149.
Go to step 4.