Lexmark X792 - Housing Interlock Assembly Removal

Repair information 4-71
7562
Go Back
Previous
Next
Housing interlock assembly removal
See “Front” on page 7-7 for the part number.
1. Remove the LVPS. See “Low-voltage power supply (LVPS) removal” on page 4-81.
2. Remove the lower frame cable cover. See “Lower frame cable cover removal” on page 4-20.
3. Remove the waste toner left cover. See “Waste toner left cover removal” on page 4-31.
4. Remove one screw (A), and remove the waste toner sensor cover.
5. Disconnect the cable (B) from the sensor, and remove three screws (C).
6. Disconnect the cable from the system board (JCVR1).
7. Route the cable through the printer to remove the assembly. Clip and remove cable ties as needed.
Note: Observe the cable routing for reinstallation.
C (88A0323)
B A (88A0323)